Rhino-shelter Steel Carport 12W X 20L X 8H Manual de usuario

3. Run a strip of Tape (11) across the end of the Panel. (See Figure G.) 4. Slide the lower Panel (1) under the edges of the Panel above. Be

INSPECTION, MAINTENANCE, AND CLEANING 1. CAUTION! Make sure to wear ANSI approved safety impact goggles and heavy work gloves before performing a

PARTS LIST AND ASSEMBLY DIAGRAM Part # Description Qty. Part # 1 Panel 10 7 2 Peak Tube 5 8 3 Rafter 10 9 4 Side Post 10

PRODUCT SPECIFICATIONS Item Description Overall Dimensions 20” Long x 12’ Wide x 8’ High Roof Panel Dimensions 10’ Long x 3’ Wide x 28 Gauge

4. Do not force the Car Shelter. Use the correct product for your application. The correct product will do the job better and safer at the rate

16. Do not allow snow to accumulate on the Car Shelter as the canopy could collapse. The Car Shelter could topple in strong winds, causing damag

UNPACKING When unpacking, check to make sure all the parts shown in the Parts List on page 12 are included. If any parts are missing or broken,

Ground Installation (“Caisson”) 1. When installing the Car Shelter to the ground, dig a post hole 12” in diameter and 24” deep. Dig ten h

2. Join the End Bases (5) and Center Bases (6) together. (See Figure B.) 3. Using a tape measure (not included), take a measurement across t

3. Once the holes are drilled, use an air compressor to blow out the concrete dust with compressed air from each of the holes. WARNING: To avoi

3. Place the bottom of the Side Posts (4) on the Base Rail (5, 6) pins and drop the Side Posts onto the pins. Then secure the Side Posts to the